Prefabricated houses are a type of temporary building that uses light steel as the frame, sandwich panels as the enclosure material, and a standard modular series for spatial combination. They are widely used in various projects and temporary scenes. The following is a detailed analysis of the advantages and disadvantages:
1. Advantages: outstanding practicality and economy
1. Fast construction and easy installation
Short construction period: No complex foundation treatment is required. Usually 10-20 people can complete the construction of a building (about 100㎡) within 1-3 days. It is suitable for emergency demand scenarios (such as post-disaster resettlement and temporary dormitories on construction sites).
Flexible assembly: Modular splicing is adopted, and the size can be adjusted according to needs (such as the length can be increased or decreased according to the 3-meter module), and the position of doors and windows can also be customized.
2. Low cost and high cost performance
Low cost: The unit cost is about 200-500 yuan/㎡, which is only 1/3-1/2 of the traditional brick-concrete building, especially suitable for cost control in short-term projects.
Fewer consumables: The main materials are steel and sandwich panels, and the usage is standardized to reduce material waste.
3. Reusable and environmentally friendly
Easy to dismantle: After dismantling, the components can be transported again, with a reuse rate of more than 70%. After multiple turnovers, the cost is further reduced.
Less construction waste: The construction process is mainly assembly-based, reducing the use of traditional building materials such as cement, sand and gravel, which is in line with the concept of green construction.
4. Strong functional adaptability
Wide range of application scenarios: can be used as dormitories, offices, warehouses, shops, etc. Some high-end versions can be equipped with toilets, kitchens, air conditioners and other facilities.
Strong environmental adaptability: Through thermal insulation sandwich panels (such as rock wool, EPS) and waterproof design, it can be used in an environment of -10℃ to 40℃, and the wind resistance level can reach 8-10.
2. Disadvantages: Structural and durability limitations
1. Short service life and high maintenance cost
Material aging problem: Sandwich panels are prone to aging due to long-term exposure to ultraviolet rays and rain erosion. If the anti-corrosion layer on the surface of the steel is damaged, it may rust. The normal service life is usually 5-10 years, and frequent maintenance is required after that.
Frequent maintenance: The roof waterproofing strips and wall joints need to be checked regularly. They may need to be repaired or reinforced after typhoons or heavy rains, which increases the cost of long-term use.
2. Safety and comfort are weak
Poor fireproof performance: If EPS sandwich panels (polystyrene) are used, the ignition point is low (about 300°C) and toxic gases are released when burning. Although rock wool boards can improve this, the overall fireproof level is still lower than that of traditional buildings.
The sound insulation and heat insulation are average: the sound insulation of a single-layer sandwich panel is about 25-30 decibels, and the noise is obvious on rainy days; the roof easily absorbs heat in summer, and an additional insulation layer or air conditioning is required, which increases energy consumption.
3. Limited structural stability
Weak ability to resist natural disasters: It is easy to be damaged when the wind and earthquake resistance levels are exceeded (for example, a typhoon above level 10 may cause the roof to overturn), and it is not suitable for areas where geological disasters are frequent.
Limited load-bearing capacity: Usually only 2 floors are allowed (1 floor is limited in some areas), the upper load needs to be strictly controlled, and it cannot meet high-rise requirements.
4. Appearance and space limitations
Single shape: The standardized design leads to a lack of individuality in appearance, and most of them are rectangular structures, which have weak visual appeal in commercial scenarios.
Low space utilization: The wall thickness is about 5-10cm, which occupies more indoor area than traditional buildings, and the floor height is usually ≤3 meters, which creates a strong sense of spatial oppression.